SplashGard™
SplashGard™ Corrosion Prevention Pipe Repair Systems Selangor, Malaysia, Kuala Lumpur (KL), Subang Jaya Services | Sceptre Power Sdn Bhd
Quantity
Description

The SplashGard™ system is a specialized coating system designed to easily adhere to wet steel surfaces and prevent corrosion. It is comprised of SplashBond™ Adhesive undercoating and Splash Wrap fiberglass cloth outerwrap, impregnated with moisture cured urethane (MCU) resin. The SplashGard™ system not only resists wave action and corrosion, but can also be applied underwater to provide structural reinforcement – perfect for use on risers.


Technical Specs

Mechanical Properties

Attribute Tensile Strength
Method ASTM D3039
Value 51,800 psi

Attribute Tensile Modulus
Method ASTM D3039
Value 3.01 x 106 psi

Attribute Poisson's Ratio
Method ASTM D3039
Value 0.077
Thermal Properties

Attribute Thermal Expansion
Method ASTM E831
Value 10.2 μm/m/°C

Attribute Heat Distortion Temperature
Method ASTM D648
Value 205 °C

Attribute Max Operating Temperature
Method ASME PCC-2
Value 185 °C

Attribute Application Temperature
Value -50°F to 120°F -46°C to 49°C
   
System Properties

Attribute Ply Thickness
Value 22 mils (0.022 inches)

Attribute Working Time
Value 20 – 30 minutes

Attribute Set Time
Value 2 hours

Attribute Cure Time
Value 24 hours

Attribute Shelf Life
Value 1 year with proper storage

Attribute Stocked Sizes
Value From 2" X 12'  to 12" X 90'
 

Installation

1. Surface Preparation

Remove all soft coatings and media blast the pipe to provide an anchor pattern (NACE 1 preferred). On dry surfaces, wipe the surface with a solvent such as Acetone, Toluene, or MEK. For structural repairs, mix and apply filler putty or paste to any defects.
   
2. Apply SplashBond

Mix equal parts of the SplashBond™ Epoxy Primer until uniform. Apply the primer to the pipe surface as instructed. Allow the primer to sit until a “peanut butter” thickness is achieved.
   
3. Apply SplashWrap

Follow the wrapping instructions for Pipe Wrap™ or A+ Wrap™, as applicable for the repair.
   
4. Apply SplashBond Outer Coat

Allow the material to cure. Then, mix and apply a coating of SplashBond™ as an outer coating.

Please leave your enquiry here, we will reply as soon as possible.


*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version