Flange Insulation Sets
Flange Insulation Sets Flange Insulation Sets Selangor, Malaysia, Kuala Lumpur (KL), Subang Jaya Services | Sceptre Power Sdn Bhd
Quantity
                                                                       TEXSEAL
 


“TexSeal” gaskets are made with a special O-Ring sealing element inlayed in the face of the gasket. This O-Ring creates a very flexible seal that requires less bolt or stud torque to maintain constant contact with the flanges sealing surface surface.
TexSeal gaskets are available in both F and E styles.

The O-Ring seal and gasket are available in a wide variety of materials.


Type D gaskets are machined from a specified insulating material and are designed to fit ring joint type groove flanges.
BX gaskets are also available.

Available Materials: Hi-Temp G-3, G-7, G-10, G11, Phenolic
A 1/4” thick closed cell neoprene sponge flange protector is recommended to prevent the flanges from shorting out.



Type E gaskets offer complete protection for both flange faces. The gasket centers easily having the same outside diameter as the flange. This prevents foreign matter from accumulating between flange faces and shorting out the flanges



Type E-RTJ combination gaskets are are made with an insulating ring joint gasket and insulating inner and outer rings. This special design gasket offers complete protection for both flange faces. The RTJ gasket provides the seal, while the 1/32'' thick inner and outer barrier rings cover the I.D. to the O.D. This prevents foreign matter from accumulating between flange faces and shorting out the flanges. It is available in most sizes and materials



Type F gaskets are fabricated to fit the raised face portion of the flange face and are designed to center on the inside of the bolt circle.
We recommend that a flange protector made from 1/4” thick closed cell neoprene sponge be used to prevent foreign matter from collecting between the flange faces.

Selections

  • TexSealFull FaceRaised FaceRTJ
              TexSeal                           Full Face                  Raised Face                        RTJ
 
 

Sealing
NS Nitrile
TS Teflon
VS Viton
GS Graphite
QS Non-Asb
  •  
  •  
Gasket
G10 G-10 Epoxy/Glass
G11 G-11 Epoxy/Glass
HTG-3 High Temp
N Nitrile Coated Phenolic
P Phenolic
Q Non-Asbestos
R Red Rubber
RD JM 940 (Red Devil)
  •  
  •  
Washers
SW Single Washer
DW Double Washer
Phenolic and Plated Steel Washers are standard
Other materials available on request are...
G10
G11
HTG-3 (Hi-Temp 450°F)
TexMica (Hi-Temp 932°F)
  •  
  •  
Sleeves
G10
G11
Integral (Minlon)
JM 940 (Red Devil)
Mylar
Nomex
Phenolic (Micarta)
Polyethylene (Poly)
Teflon


Please leave your enquiry here, we will reply as soon as possible.


*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version